Why Ours?

Because of our excellent reputation for uncompromised quality, component selection and attention to detail is evident in all aspects of the Perfect Fit™ product line! Every component was chosen on its superior design and quality rather than a low cost.

Advantages of all of our Street Rod Coolers

Engineered with carefully sized, large separate A/C and Heat coils just like factory (OE) systems. The separate coils improve the cooling and heating capacity of the total system.

All of the mode doors and shafts are 1 piece composite extrusions. This exclusive feature allows for larger diameter bearing surfaces and longer service life.

All of the perfect fit systems are assembled using spring metal retainers and are screwed together to enable you to service the entire system.

State of the art High Output OEM style blower assemblies from “Spal” with heat sink speed controllers for thermal protection.

Excellent air volume with less electrical amperage. This is very important when installing on older vehicles where the electrical systems are not upgraded to modern standards.

Four A/C-Heat outlets for superior comfort; not 3 like some competitors' units.

The Evaporator unit can be mounted in the center of the firewall or on the passenger side next to the passenger kick panel. When mounted on the passenger side, our exclusive remote heat dump lets you distribute heated air to the driver’s side floor or any other remote location you prefer. (A passenger side mount with some competitors’ models would allow hot air flow only on the passenger side).

Two Defrost outlets for proper defrost performance; not one or even none like some competitors’ units.

And unlike many competitors' glued together units, our case disassembles for repair or service.

Continue to page 2…